Love the project, love the blog! May I ask you how you got the photo's this large on blogspot? I can't get them to be any larger than roughly 2/3rd of your photo's :(
I'm kinda thinking along the same lines as Evan too. I went back to the first sketch where the wheels were just marked in and liked the lighter color but it's a tough call. In the end it's your bike though, I can't wait to see the seat though, that ribbed red design is sooo fresh looking! I know it would add cost but if you could somehow stamp the leather dead center on the back edge with some cool logo I think it would be perfect!
Now let's see some holes in that front rotor :)
ReplyDeleteHey man,
ReplyDeleteLove the project, love the blog! May I ask you how you got the photo's this large on blogspot? I can't get them to be any larger than roughly 2/3rd of your photo's :(
Match the wheels to the tank, done and done!
ReplyDeleteThat's what I was thinking too Evan. Will be sketching up some variations next.
ReplyDeleteMIOB - remove the side columns and increase the width in Design > Template Designer > Adjust Width / Layout
Also, I found out the Maxxis DTR-1's aren't available in 18". Boo.
I'm kinda thinking along the same lines as Evan too. I went back to the first sketch where the wheels were just marked in and liked the lighter color but it's a tough call. In the end it's your bike though, I can't wait to see the seat though, that ribbed red design is sooo fresh looking! I know it would add cost but if you could somehow stamp the leather dead center on the back edge with some cool logo I think it would be perfect!
ReplyDelete